Several effective methods for drying pollen

<

The pollen mass of the pollen group just collected by the bees is about 20%, and it is prone to fungal infection and mold deterioration at room temperature. It is generally believed that the water content of the pollen is below 5% to prevent mildew. The water content of commercial pollen needs to be 4%. The commonly used drying methods are the following:

1. Sun drying

The bee pollen is evenly spread on bamboo rafts, mats, white cloth or white paper, about 10 mm thick, and then covered with a layer of white cloth, placed in the sun under the sun, put away in the evening, the sun 3 to 5 days, the pollen was hard particles Shape, can not be broken by hand.

2. Chemical drying

Put a proper amount of chemical desiccant at the bottom of the glass dryer, spread a layer of absorbent paper or white cloth on the griddle, put the pollen cluster on it, cover it and place it for several days. Drying 1 kg of pollen requires 2 kg of discolored silica gel, or 1 kg of calcium chloride, or 1 kg of anhydrous magnesium sulfate. Desiccant after absorbing water, can be heated and dried, and used repeatedly, but the drying time is long and the efficiency is low.

3. Heating and drying

Spread a cloth on the soil of the bandits and spread a layer of 10-20 mm thick pollen, heat and dry.

4. Far-infrared drying

The far-infrared pollen drying oven developed by the Bee Research Institute of the Chinese Academy of Agricultural Sciences uses direct-heating far-infrared heating elements, which has the features of low power consumption and high thermal efficiency. When used, install according to the instructions. Put 500 to 750 grams of pollen into each of the four pollen drawers. The amount of pollen in each drawer should be approximately equal and the entire drawer should be evenly covered. When used for the first time, the temperature of each drawer is determined according to the specification, the temperature is set at 40-45°C, and it is adjusted several times until the temperature of the pollen layer is maintained at 40-45°C. At regular intervals, observe the temperature of the pollen and adjust the temperature control knob to keep the temperature stable. After drying for 2 to 3 hours, the upper and lower drawers are exchanged to make the pollen more uniform.

Auto Recovery High Speed Door

Advantages:
The advantage of Self Reparing High Speed Doors are self-reparing,easy to clean,complete safe,energy saving and so on.
If the door curtain comes out of its guides(for example in the event of impact with a forklift),the system will reset the cutrain back intp the guide during the next opening cycle autimatically

Motor System:
Germany Famous Brand-SEW
Power Supply: 0.75kw, 1.5kw, 2.2kw
The incremental encoder mounted is attached to the end of the drum shaft.

Self-Repairing Door Curtain:
Made of reinforced PVC, with flexible weighted soft bottom edge.
The edge of curtain has continuous injection molded teeth that then move up and down in a self-lubricating polyethylene track attached to structural galvanized side frames.

PVC Curtain

Grey,Yellow grid,Purple,Green,Light green,Black,Perforated Yellow grid,White,Blue,White grid,Sky Blue,Yellow,Orange,Red

Color curtain:0.8mmthickness.
Transparent curtain:1.2mm.

Function:insect prevention


Opening Way
Forklift cross --Magnetic loop with push button
People cross --Radar sensor with push button
Photocell sensor/Airbag to avoid hurt people when the door closing and someone cross.

Auto Recovery High Speed Door,self-recovery high speed door,self-repair high speed door, high speed zipper door, zipper high speed door

SHENZHEN HONGFA AUTOMATIC DOOR CO., LTD , http://www.hongfafrs.com